Athena C10 line Manual de Instruções descarregar pdf (Página 29)

107 108 Communications protocol

Prot

R/W

108 109 Baud rate

baud

R/W

109 110 Retransmission range

retr

R/W

110 111 Retransmission signal selection

rtH

R/W

111 112 Current transformer range

Ht.F.S

R/W

112 113 Password

Code

R/W

113 114 RTX low range calibration value (Reserved)

CAL.3

R/W

114 115 RTX high range calibration value (Reserved)

CAL.4

R/W

115 116 Timer operating mode

t.Mod

R/W

116 117 Timer action

t.Act

R/W

117 118 Digital input function

IL.Fn

R/W

118 119 -

119 120 -

120 121 Factory code

R(W)

121 122 Product code (“M4”)

122 123 -

123 124 Software release (p. es. “ 00A”)

124 125 -

125 126 Custom code

126 127 -

127 128 -

Notes:

1. Assignment of Setpoint to the addresses JbuS 2 and 4 writes the

Computer Setpoint. It is different from the Local Setpoint, which can

be in any case set by keypad.

2. Assignment of output at the address JbuS 3 is only possible if the

the Auto/Man option if fitted and when the controller is in Manual

mode.

3. Assignment of Setpoint to the address JbuS 5 writes the Local

Setpoint (the previous value is lost).

4. In case of ON - OFF output (address JbuS 6) the proportional band

is substituted by the output hysteresis.

5. All the configuration parameters are accepted, if valid, but not

brought into effect. To execute the reconfiguration procedure and

bring the changes into effect, the code 55AAh must be written at the

address JbuS 121.

6. Address JbuS 121 is read only, but if the code 55AAh (21930d) is

written at this address, the configuration is brought into effect.

7. The JbuS 122 + 123 and 124 + 125 addresses contain the strings

(of 4 characters) for the product and release codes: each address

represents two characters, the most significant byte in the word

contains the ASCII code of the second.

8. To select the engineering unit, the value between 0 and 10 must be

assigned as per the below table:

Engineering unit Serial value

°C

°F

none

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 106 107

Comentários a estes Manuais

Sem comentários

Athena C10 line Manual de Instruções Página 29

Comentários a estes Manuais

Manuais e produtos relacionados com não Athena C10 line