Athena C10 line Manual de Instruções descarregar pdf (Página 43)

111 112 CT primary high range

Ht.F.S

R/W

112 113 Password

Code

R/W

113 114 Retransm. calibration low range (for Athena

Controls only)

CAL.3

R/W

114 115 Retransm. calibration high range (for Athena

Controls only)

CAL.4

R/W

115 116 Timer setting

t.Mod

R/W

116 117 Timer action

t.Act

R/W

117 118 IL1 digital input function

IL1

R/W

118 119 IL2 digital input function

IL2

R/W

119 120 IL3 digital input function

IL3

R/W

Address

Modbus JbuS Variable Parameter

code

Type

120 121 Manufacturer code (600 for Athena Controls) R(W)

121 122 Product code (“X1” or X3”)

note X3=X400 product R

122 123 R

123 124 Release code (p. es. “ 00A”)

124 125 R

125 126 Custom code R

126 127 - - -

127 128 - - -

Notes:

1. Assignment of Setpoint to the addresses JbuS 2 and 4 writes the

Computer Setpoint. It is different from the Local Setpoint, which can

be in any case set by keypad.

2. Assignment of output at the address JbuS 3 is only possible if the the

Auto/Man option if fitted and when the controller is in Manual mode.

3. Assignment of Setpoint to the address JbuS 5 writes the Local

Setpoint (the previous value is lost).

4. In case of ON - OFF output (address JbuS 6) the proportional band

is substituted by the output hysteresis.

5. All the configuration parameters are accepted, if valid, but not

brought into effect. To execute the reconfiguration procedure and

bring the changes into effect, the code 55AAh must be written at the

address JbuS 121.

6. Address JbuS 121 is read only, but if the code 55AAh (21930d) is

written at this address, the configuration is brought into effect.

7. The JbuS 122 + 123 and 124 + 125 addresses contain the strings (of

4 characters) for the product and release codes: each address

represents two characters, the most significant byte in the word

contains the ASCII code of the second.

8. To select the program status, the value between 0 and 4 must be

assigned as per the below table:

Program status Serial value

Reset 0

Hold 1

Run 2

Hold / Back (note) 3

Program end 4

Note: If the PV controlled input value exceeds the band, the

controller switches automatically to this mode.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 106 107

Comentários a estes Manuais

Sem comentários

Athena C10 line Manual de Instruções Página 43

Comentários a estes Manuais

Manuais e produtos relacionados com não Athena C10 line