Athena C10 line Manual de Instruções descarregar pdf (Página 61)

12.6 RS-485 Configuration Dip Switch

On the RS485 board a 4 position dip Switch is provided. It enables the

correct hardware configuration of the instrument serial comm.s port as

follows:

Position On OFF

1 Polarisation +5Vcc Polarisation excluded

2 Termination set Termination excluded

3 Polarisation 0 Vcc Polarisation excluded

4 - -

13. Configuration software for Platinum controllers

The configuration software APG2SW4 can be used with all the Platinum



instruments: C10, M10, M300, M400, M5000, X100, X400 and X5000,

even those without the RS 485 communications option.

Instruments C10, M10, M300 and M400 without

the RS 485

communications option can be configured using this software, but the

special cable APG2SCI, (available separately), will be required to

interface between the computer port and the instrument.

For instruments C10, M10, M300 and M400 without

the RS 485

communications option, connect the special cable APG2SCI to a spare

port on the computer and the crimp connectors to terminals 10 – brown

and 11 – black on the instrument. The computer and the instrument

should be turned off during this procedure.

For instruments C10, M10, M300 and M400, terminals 10 and 11 are

also the SSR drive voltage output. To avoid a communication error, open

circuit the sensor input terminals, to prevent the SSR drive output from

turning on. Also, for previously configured instruments, ensure that the

configuration code, ‘ConF’ ends in a ‘0’ e.g. 2000

, i.e. Alarm 2 is turned

off and that the SSR drive voltage output is not used as main output.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 106 107

Sem comentários

Athena C10 line Manual de Instruções Página 61